diff options
Diffstat (limited to 'drivers/gpu/drm/i915/intel_drv.h')
| -rw-r--r-- | drivers/gpu/drm/i915/intel_drv.h | 109 |
1 files changed, 102 insertions, 7 deletions
diff --git a/drivers/gpu/drm/i915/intel_drv.h b/drivers/gpu/drm/i915/intel_drv.h index cdcbeb595bb1..468ec1e90e16 100644 --- a/drivers/gpu/drm/i915/intel_drv.h +++ b/drivers/gpu/drm/i915/intel_drv.h @@ -41,20 +41,21 @@ #include <drm/drm_atomic.h> /** - * _wait_for - magic (register) wait macro + * __wait_for - magic wait macro * - * Does the right thing for modeset paths when run under kdgb or similar atomic - * contexts. Note that it's important that we check the condition again after - * having timed out, since the timeout could be due to preemption or similar and - * we've never had a chance to check the condition before the timeout. + * Macro to help avoid open coding check/wait/timeout patterns. Note that it's + * important that we check the condition again after having timed out, since the + * timeout could be due to preemption or similar and we've never had a chance to + * check the condition before the timeout. */ -#define _wait_for(COND, US, Wmin, Wmax) ({ \ +#define __wait_for(OP, COND, US, Wmin, Wmax) ({ \ unsigned long timeout__ = jiffies + usecs_to_jiffies(US) + 1; \ long wait__ = (Wmin); /* recommended min for usleep is 10 us */ \ int ret__; \ might_sleep(); \ for (;;) { \ bool expired__ = time_after(jiffies, timeout__); \ + OP; \ if (COND) { \ ret__ = 0; \ break; \ @@ -70,7 +71,9 @@ ret__; \ }) -#define wait_for(COND, MS) _wait_for((COND), (MS) * 1000, 10, 1000) +#define _wait_for(COND, US, Wmin, Wmax) __wait_for(, (COND), (US), (Wmin), \ + (Wmax)) +#define wait_for(COND, MS) _wait_for((COND), (MS) * 1000, 10, 1000) /* If CONFIG_PREEMPT_COUNT is disabled, in_atomic() always reports false. */ #if defined(CONFIG_DRM_I915_DEBUG) && defined(CONFIG_PREEMPT_COUNT) @@ -298,6 +301,80 @@ struct intel_panel { } backlight; }; +/* + * This structure serves as a translation layer between the generic HDCP code + * and the bus-specific code. What that means is that HDCP over HDMI differs + * from HDCP over DP, so to account for these differences, we need to + * communicate with the receiver through this shim. + * + * For completeness, the 2 buses differ in the following ways: + * - DP AUX vs. DDC + * HDCP registers on the receiver are set via DP AUX for DP, and + * they are set via DDC for HDMI. + * - Receiver register offsets + * The offsets of the registers are different for DP vs. HDMI + * - Receiver register masks/offsets + * For instance, the ready bit for the KSV fifo is in a different + * place on DP vs HDMI + * - Receiver register names + * Seriously. In the DP spec, the 16-bit register containing + * downstream information is called BINFO, on HDMI it's called + * BSTATUS. To confuse matters further, DP has a BSTATUS register + * with a completely different definition. + * - KSV FIFO + * On HDMI, the ksv fifo is read all at once, whereas on DP it must + * be read 3 keys at a time + * - Aksv output + * Since Aksv is hidden in hardware, there's different procedures + * to send it over DP AUX vs DDC + */ +struct intel_hdcp_shim { + /* Outputs the transmitter's An and Aksv values to the receiver. */ + int (*write_an_aksv)(struct intel_digital_port *intel_dig_port, u8 *an); + + /* Reads the receiver's key selection vector */ + int (*read_bksv)(struct intel_digital_port *intel_dig_port, u8 *bksv); + + /* + * Reads BINFO from DP receivers and BSTATUS from HDMI receivers. The + * definitions are the same in the respective specs, but the names are + * different. Call it BSTATUS since that's the name the HDMI spec + * uses and it was there first. + */ + int (*read_bstatus)(struct intel_digital_port *intel_dig_port, + u8 *bstatus); + + /* Determines whether a repeater is present downstream */ + int (*repeater_present)(struct intel_digital_port *intel_dig_port, + bool *repeater_present); + + /* Reads the receiver's Ri' value */ + int (*read_ri_prime)(struct intel_digital_port *intel_dig_port, u8 *ri); + + /* Determines if the receiver's KSV FIFO is ready for consumption */ + int (*read_ksv_ready)(struct intel_digital_port *intel_dig_port, + bool *ksv_ready); + + /* Reads the ksv fifo for num_downstream devices */ + int (*read_ksv_fifo)(struct intel_digital_port *intel_dig_port, + int num_downstream, u8 *ksv_fifo); + + /* Reads a 32-bit part of V' from the receiver */ + int (*read_v_prime_part)(struct intel_digital_port *intel_dig_port, + int i, u32 *part); + + /* Enables HDCP signalling on the port */ + int (*toggle_signalling)(struct intel_digital_port *intel_dig_port, + bool enable); + + /* Ensures the link is still protected */ + bool (*check_link)(struct intel_digital_port *intel_dig_port); + + /* Detects panel's hdcp capability. This is optional for HDMI. */ + int (*hdcp_capable)(struct intel_digital_port *intel_dig_port, + bool *hdcp_capable); +}; + struct intel_connector { struct drm_connector base; /* @@ -329,6 +406,12 @@ struct intel_connector { /* Work struct to schedule a uevent on link train failure */ struct work_struct modeset_retry_work; + + const struct intel_hdcp_shim *hdcp_shim; + struct mutex hdcp_mutex; + uint64_t hdcp_value; /* protected by hdcp_mutex */ + struct delayed_work hdcp_check_work; + struct work_struct hdcp_prop_work; }; struct intel_digital_connector_state { @@ -1297,6 +1380,8 @@ void intel_ddi_compute_min_voltage_level(struct drm_i915_private *dev_priv, u32 bxt_signal_levels(struct intel_dp *intel_dp); uint32_t ddi_signal_levels(struct intel_dp *intel_dp); u8 intel_ddi_dp_voltage_max(struct intel_encoder *encoder); +int intel_ddi_toggle_hdcp_signalling(struct intel_encoder *intel_encoder, + bool enable); unsigned int intel_fb_align_height(const struct drm_framebuffer *fb, int plane, unsigned int height); @@ -1757,6 +1842,16 @@ static inline void intel_backlight_device_unregister(struct intel_connector *con } #endif /* CONFIG_BACKLIGHT_CLASS_DEVICE */ +/* intel_hdcp.c */ +void intel_hdcp_atomic_check(struct drm_connector *connector, + struct drm_connector_state *old_state, + struct drm_connector_state *new_state); +int intel_hdcp_init(struct intel_connector *connector, + const struct intel_hdcp_shim *hdcp_shim); +int intel_hdcp_enable(struct intel_connector *connector); +int intel_hdcp_disable(struct intel_connector *connector); +int intel_hdcp_check_link(struct intel_connector *connector); +bool is_hdcp_supported(struct drm_i915_private *dev_priv, enum port port); /* intel_psr.c */ #define CAN_PSR(dev_priv) (HAS_PSR(dev_priv) && dev_priv->psr.sink_support) |