diff options
Diffstat (limited to 'include/configs/actux2.h')
| -rw-r--r-- | include/configs/actux2.h | 66 |
1 files changed, 33 insertions, 33 deletions
diff --git a/include/configs/actux2.h b/include/configs/actux2.h index a3f5a4a43c..7e6e8f2824 100644 --- a/include/configs/actux2.h +++ b/include/configs/actux2.h @@ -32,7 +32,7 @@ #define CONFIG_DISPLAY_CPUINFO 1 #define CONFIG_DISPLAY_BOARDINFO 1 -#define CFG_IXP425_CONSOLE IXP425_UART2 +#define CONFIG_SYS_IXP425_CONSOLE IXP425_UART2 #define CONFIG_BAUDRATE 115200 #define CONFIG_BOOTDELAY 5 #define CONFIG_ZERO_BOOTDELAY_CHECK /* check for keypress on bootdelay==0 */ @@ -43,9 +43,9 @@ #undef CONFIG_USE_IRQ /* Size of malloc() pool */ -#define CFG_MALLOC_LEN (CONFIG_ENV_SIZE + 128*1024) +#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128*1024) /* size in bytes reserved for initial data */ -#define CFG_GBL_DATA_SIZE 128 +#define CONFIG_SYS_GBL_DATA_SIZE 128 /* allow to overwrite serial and ethaddr */ #define CONFIG_ENV_OVERWRITE @@ -71,30 +71,30 @@ #endif /* Miscellaneous configurable options */ -#define CFG_LONGHELP -#define CFG_PROMPT "=> " +#define CONFIG_SYS_LONGHELP +#define CONFIG_SYS_PROMPT "=> " /* Console I/O Buffer Size */ -#define CFG_CBSIZE 256 +#define CONFIG_SYS_CBSIZE 256 /* Print Buffer Size */ -#define CFG_PBSIZE (CFG_CBSIZE+sizeof(CFG_PROMPT)+16) +#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* max number of command args */ -#define CFG_MAXARGS 16 +#define CONFIG_SYS_MAXARGS 16 /* Boot Argument Buffer Size */ -#define CFG_BARGSIZE CFG_CBSIZE +#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE -#define CFG_MEMTEST_START 0x00400000 -#define CFG_MEMTEST_END 0x00800000 +#define CONFIG_SYS_MEMTEST_START 0x00400000 +#define CONFIG_SYS_MEMTEST_END 0x00800000 /* everything, incl board info, in Hz */ -#undef CFG_CLKS_IN_HZ +#undef CONFIG_SYS_CLKS_IN_HZ /* spec says 66.666 MHz, but it appears to be 33 */ -#define CFG_HZ 3333333 +#define CONFIG_SYS_HZ 3333333 /* default load address */ -#define CFG_LOAD_ADDR 0x00010000 +#define CONFIG_SYS_LOAD_ADDR 0x00010000 /* valid baudrates */ -#define CFG_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, \ +#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, \ 115200, 230400 } #define CONFIG_SERIAL_RTS_ACTIVE 1 @@ -109,39 +109,39 @@ #endif /* Expansion bus settings */ -#define CFG_EXP_CS0 0xbd113042 +#define CONFIG_SYS_EXP_CS0 0xbd113042 /* SDRAM settings */ #define CONFIG_NR_DRAM_BANKS 1 #define PHYS_SDRAM_1 0x00000000 -#define CFG_DRAM_BASE 0x00000000 +#define CONFIG_SYS_DRAM_BASE 0x00000000 /* 16MB SDRAM */ -#define CFG_SDR_CONFIG 0x3A +#define CONFIG_SYS_SDR_CONFIG 0x3A #define PHYS_SDRAM_1_SIZE 0x01000000 -#define CFG_SDRAM_REFRESH_CNT 0x81a -#define CFG_SDR_MODE_CONFIG 0x1 -#define CFG_DRAM_SIZE 0x01000000 +#define CONFIG_SYS_SDRAM_REFRESH_CNT 0x81a +#define CONFIG_SYS_SDR_MODE_CONFIG 0x1 +#define CONFIG_SYS_DRAM_SIZE 0x01000000 /* FLASH organization */ -#define CFG_MAX_FLASH_BANKS 1 +#define CONFIG_SYS_MAX_FLASH_BANKS 1 /* max number of sectors on one chip */ -#define CFG_MAX_FLASH_SECT 140 +#define CONFIG_SYS_MAX_FLASH_SECT 140 #define PHYS_FLASH_1 0x50000000 -#define CFG_FLASH_BANKS_LIST { PHYS_FLASH_1 } +#define CONFIG_SYS_FLASH_BANKS_LIST { PHYS_FLASH_1 } -#define CFG_FLASH_BASE PHYS_FLASH_1 -#define CFG_MONITOR_BASE PHYS_FLASH_1 -#define CFG_MONITOR_LEN (256 << 10) +#define CONFIG_SYS_FLASH_BASE PHYS_FLASH_1 +#define CONFIG_SYS_MONITOR_BASE PHYS_FLASH_1 +#define CONFIG_SYS_MONITOR_LEN (256 << 10) /* Use common CFI driver */ -#define CFG_FLASH_CFI +#define CONFIG_SYS_FLASH_CFI #define CONFIG_FLASH_CFI_DRIVER /* no byte writes on IXP4xx */ -#define CFG_FLASH_CFI_WIDTH FLASH_CFI_16BIT +#define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT /* print 'E' for empty sector on flinfo */ -#define CFG_FLASH_EMPTY_INFO +#define CONFIG_SYS_FLASH_EMPTY_INFO /* Ethernet */ @@ -155,7 +155,7 @@ /* MII PHY management */ #define CONFIG_MII 1 /* Number of ethernet rx buffers & descriptors */ -#define CFG_RX_ETH_BUFFER 16 +#define CONFIG_SYS_RX_ETH_BUFFER 16 #define CONFIG_RESET_PHY_R 1 /* ethernet switch connected to MII port */ #define CONFIG_MII_ETHSWITCH 1 @@ -173,7 +173,7 @@ #define CONFIG_BOOTP_HOSTNAME /* Cache Configuration */ -#define CFG_CACHELINE_SIZE 32 +#define CONFIG_SYS_CACHELINE_SIZE 32 /* * environment organization: @@ -182,7 +182,7 @@ #define CONFIG_ENV_IS_IN_FLASH 1 #define CONFIG_ENV_SIZE 0x2000 #define CONFIG_ENV_ADDR (PHYS_FLASH_1 + 0x4000) -#define CFG_USE_PPCENV 1 +#define CONFIG_SYS_USE_PPCENV 1 #define CONFIG_EXTRA_ENV_SETTINGS \ "mtd=IXP4XX-Flash.0:256k(uboot),64k(ucode),1152k(linux),-(root)\0" \ |