From 1025774ce411f2bd4b059ad7b53f0003569b74fa Mon Sep 17 00:00:00 2001 From: Christoph Hellwig Date: Fri, 4 Jun 2010 11:30:02 +0200 Subject: remove inode_setattr Replace inode_setattr with opencoded variants of it in all callers. This moves the remaining call to vmtruncate into the filesystem methods where it can be replaced with the proper truncate sequence. In a few cases it was obvious that we would never end up calling vmtruncate so it was left out in the opencoded variant: spufs: explicitly checks for ATTR_SIZE earlier btrfs,hugetlbfs,logfs,dlmfs: explicitly clears ATTR_SIZE earlier ufs: contains an opencoded simple_seattr + truncate that sets the filesize just above In addition to that ncpfs called inode_setattr with handcrafted iattrs, which allowed to trim down the opencoded variant. Signed-off-by: Christoph Hellwig Signed-off-by: Al Viro --- fs/gfs2/ops_inode.c | 12 ++++++++++-- 1 file changed, 10 insertions(+), 2 deletions(-) (limited to 'fs/gfs2/ops_inode.c') diff --git a/fs/gfs2/ops_inode.c b/fs/gfs2/ops_inode.c index 98cdd05f3316..d7d410a4ca42 100644 --- a/fs/gfs2/ops_inode.c +++ b/fs/gfs2/ops_inode.c @@ -1136,8 +1136,16 @@ static int setattr_chown(struct inode *inode, struct iattr *attr) if (error) goto out_end_trans; - error = inode_setattr(inode, attr); - gfs2_assert_warn(sdp, !error); + if ((attr->ia_valid & ATTR_SIZE) && + attr->ia_size != i_size_read(inode)) { + int error; + + error = vmtruncate(inode, attr->ia_size); + gfs2_assert_warn(sdp, !error); + } + + setattr_copy(inode, attr); + mark_inode_dirty(inode); gfs2_trans_add_bh(ip->i_gl, dibh, 1); gfs2_dinode_out(ip, dibh->b_data); -- cgit v1.2.3 From 2c27c65ed0696f0b5df2dad2cf6462d72164d547 Mon Sep 17 00:00:00 2001 From: Christoph Hellwig Date: Fri, 4 Jun 2010 11:30:04 +0200 Subject: check ATTR_SIZE contraints in inode_change_ok Make sure we check the truncate constraints early on in ->setattr by adding those checks to inode_change_ok. Also clean up and document inode_change_ok to make this obvious. As a fallout we don't have to call inode_newsize_ok from simple_setsize and simplify it down to a truncate_setsize which doesn't return an error. This simplifies a lot of setattr implementations and means we use truncate_setsize almost everywhere. Get rid of fat_setsize now that it's trivial and mark ext2_setsize static to make the calling convention obvious. Keep the inode_newsize_ok in vmtruncate for now as all callers need an audit for its removal anyway. Note: setattr code in ecryptfs doesn't call inode_change_ok at all and needs a deeper audit, but that is left for later. Signed-off-by: Christoph Hellwig Signed-off-by: Al Viro --- fs/gfs2/ops_inode.c | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-) (limited to 'fs/gfs2/ops_inode.c') diff --git a/fs/gfs2/ops_inode.c b/fs/gfs2/ops_inode.c index d7d410a4ca42..1009be2c9737 100644 --- a/fs/gfs2/ops_inode.c +++ b/fs/gfs2/ops_inode.c @@ -1072,7 +1072,7 @@ int gfs2_permission(struct inode *inode, int mask) } /* - * XXX: should be changed to have proper ordering by opencoding simple_setsize + * XXX(truncate): the truncate_setsize calls should be moved to the end. */ static int setattr_size(struct inode *inode, struct iattr *attr) { @@ -1084,10 +1084,8 @@ static int setattr_size(struct inode *inode, struct iattr *attr) error = gfs2_trans_begin(sdp, 0, sdp->sd_jdesc->jd_blocks); if (error) return error; - error = simple_setsize(inode, attr->ia_size); + truncate_setsize(inode, attr->ia_size); gfs2_trans_end(sdp); - if (error) - return error; } error = gfs2_truncatei(ip, attr->ia_size); -- cgit v1.2.3