diff options
Diffstat (limited to 'include/linux/mtd/nand.h')
| -rw-r--r-- | include/linux/mtd/nand.h | 176 |
1 files changed, 157 insertions, 19 deletions
diff --git a/include/linux/mtd/nand.h b/include/linux/mtd/nand.h index 9e6c8f9f306e..450d61ec7f06 100644 --- a/include/linux/mtd/nand.h +++ b/include/linux/mtd/nand.h @@ -52,14 +52,6 @@ extern int nand_unlock(struct mtd_info *mtd, loff_t ofs, uint64_t len); #define NAND_MAX_CHIPS 8 /* - * This constant declares the max. oobsize / page, which - * is supported now. If you add a chip with bigger oobsize/page - * adjust this accordingly. - */ -#define NAND_MAX_OOBSIZE 744 -#define NAND_MAX_PAGESIZE 8192 - -/* * Constants for hardware specific CLE/ALE/NCE function * * These are bits which can be or'ed to set/clear multiple @@ -219,6 +211,9 @@ struct nand_chip; /* ONFI feature address */ #define ONFI_FEATURE_ADDR_TIMING_MODE 0x1 +/* Vendor-specific feature address (Micron) */ +#define ONFI_FEATURE_ADDR_READ_RETRY 0x89 + /* ONFI subfeature parameters length */ #define ONFI_SUBFEATURE_PARAM_LEN 4 @@ -279,16 +274,17 @@ struct nand_onfi_params { __le16 io_pin_capacitance_typ; __le16 input_pin_capacitance_typ; u8 input_pin_capacitance_max; - u8 driver_strenght_support; + u8 driver_strength_support; __le16 t_int_r; __le16 t_ald; u8 reserved4[7]; /* vendor */ - u8 reserved5[90]; + __le16 vendor_revision; + u8 vendor[88]; __le16 crc; -} __attribute__((packed)); +} __packed; #define ONFI_CRC_BASE 0x4F4E @@ -326,6 +322,104 @@ struct onfi_ext_param_page { */ } __packed; +struct nand_onfi_vendor_micron { + u8 two_plane_read; + u8 read_cache; + u8 read_unique_id; + u8 dq_imped; + u8 dq_imped_num_settings; + u8 dq_imped_feat_addr; + u8 rb_pulldown_strength; + u8 rb_pulldown_strength_feat_addr; + u8 rb_pulldown_strength_num_settings; + u8 otp_mode; + u8 otp_page_start; + u8 otp_data_prot_addr; + u8 otp_num_pages; + u8 otp_feat_addr; + u8 read_retry_options; + u8 reserved[72]; + u8 param_revision; +} __packed; + +struct jedec_ecc_info { + u8 ecc_bits; + u8 codeword_size; + __le16 bb_per_lun; + __le16 block_endurance; + u8 reserved[2]; +} __packed; + +/* JEDEC features */ +#define JEDEC_FEATURE_16_BIT_BUS (1 << 0) + +struct nand_jedec_params { + /* rev info and features block */ + /* 'J' 'E' 'S' 'D' */ + u8 sig[4]; + __le16 revision; + __le16 features; + u8 opt_cmd[3]; + __le16 sec_cmd; + u8 num_of_param_pages; + u8 reserved0[18]; + + /* manufacturer information block */ + char manufacturer[12]; + char model[20]; + u8 jedec_id[6]; + u8 reserved1[10]; + + /* memory organization block */ + __le32 byte_per_page; + __le16 spare_bytes_per_page; + u8 reserved2[6]; + __le32 pages_per_block; + __le32 blocks_per_lun; + u8 lun_count; + u8 addr_cycles; + u8 bits_per_cell; + u8 programs_per_page; + u8 multi_plane_addr; + u8 multi_plane_op_attr; + u8 reserved3[38]; + + /* electrical parameter block */ + __le16 async_sdr_speed_grade; + __le16 toggle_ddr_speed_grade; + __le16 sync_ddr_speed_grade; + u8 async_sdr_features; + u8 toggle_ddr_features; + u8 sync_ddr_features; + __le16 t_prog; + __le16 t_bers; + __le16 t_r; + __le16 t_r_multi_plane; + __le16 t_ccs; + __le16 io_pin_capacitance_typ; + __le16 input_pin_capacitance_typ; + __le16 clk_pin_capacitance_typ; + u8 driver_strength_support; + __le16 t_ald; + u8 reserved4[36]; + + /* ECC and endurance block */ + u8 guaranteed_good_blocks; + __le16 guaranteed_block_endurance; + struct jedec_ecc_info ecc_info[4]; + u8 reserved5[29]; + + /* reserved */ + u8 reserved6[148]; + + /* vendor */ + __le16 vendor_rev_num; + u8 reserved7[88]; + + /* CRC for Parameter Page */ + __le16 crc; +} __packed; + /** * struct nand_hw_control - Control structure for hardware controller (e.g ECC generator) shared among independent devices * @lock: protection lock @@ -394,7 +488,7 @@ struct nand_ecc_ctrl { int (*read_page)(struct mtd_info *mtd, struct nand_chip *chip, uint8_t *buf, int oob_required, int page); int (*read_subpage)(struct mtd_info *mtd, struct nand_chip *chip, - uint32_t offs, uint32_t len, uint8_t *buf); + uint32_t offs, uint32_t len, uint8_t *buf, int page); int (*write_subpage)(struct mtd_info *mtd, struct nand_chip *chip, uint32_t offset, uint32_t data_len, const uint8_t *data_buf, int oob_required); @@ -411,17 +505,17 @@ struct nand_ecc_ctrl { /** * struct nand_buffers - buffer structure for read/write - * @ecccalc: buffer for calculated ECC - * @ecccode: buffer for ECC read from flash - * @databuf: buffer for data - dynamically sized + * @ecccalc: buffer pointer for calculated ECC, size is oobsize. + * @ecccode: buffer pointer for ECC read from flash, size is oobsize. + * @databuf: buffer pointer for data, size is (page size + oobsize). * * Do not change the order of buffers. databuf and oobrbuf must be in * consecutive order. */ struct nand_buffers { - uint8_t ecccalc[NAND_MAX_OOBSIZE]; - uint8_t ecccode[NAND_MAX_OOBSIZE]; - uint8_t databuf[NAND_MAX_PAGESIZE + NAND_MAX_OOBSIZE]; + uint8_t *ecccalc; + uint8_t *ecccode; + uint8_t *databuf; }; /** @@ -432,6 +526,8 @@ struct nand_buffers { * flash device. * @read_byte: [REPLACEABLE] read one byte from the chip * @read_word: [REPLACEABLE] read one word from the chip + * @write_byte: [REPLACEABLE] write a single byte to the chip on the + * low 8 I/O lines * @write_buf: [REPLACEABLE] write data from the buffer to the chip * @read_buf: [REPLACEABLE] read data from the chip into the buffer * @select_chip: [REPLACEABLE] select chip nr @@ -451,6 +547,8 @@ struct nand_buffers { * commands to the chip. * @waitfunc: [REPLACEABLE] hardwarespecific function for wait on * ready. + * @setup_read_retry: [FLASHSPECIFIC] flash (vendor) specific function for + * setting the read-retry mode. Mostly needed for MLC NAND. * @ecc: [BOARDSPECIFIC] ECC control structure * @buffers: buffer structure for read/write * @hwcontrol: platform-specific hardware control structure @@ -495,8 +593,13 @@ struct nand_buffers { * @subpagesize: [INTERN] holds the subpagesize * @onfi_version: [INTERN] holds the chip ONFI version (BCD encoded), * non 0 if ONFI supported. + * @jedec_version: [INTERN] holds the chip JEDEC version (BCD encoded), + * non 0 if JEDEC supported. * @onfi_params: [INTERN] holds the ONFI page parameter when ONFI is * supported, 0 otherwise. + * @jedec_params: [INTERN] holds the JEDEC parameter page when JEDEC is + * supported, 0 otherwise. + * @read_retries: [INTERN] the number of read retry modes supported * @onfi_set_features: [REPLACEABLE] set the features for ONFI nand * @onfi_get_features: [REPLACEABLE] get the features for ONFI nand * @bbt: [INTERN] bad block table pointer @@ -521,6 +624,7 @@ struct nand_chip { uint8_t (*read_byte)(struct mtd_info *mtd); u16 (*read_word)(struct mtd_info *mtd); + void (*write_byte)(struct mtd_info *mtd, uint8_t byte); void (*write_buf)(struct mtd_info *mtd, const uint8_t *buf, int len); void (*read_buf)(struct mtd_info *mtd, uint8_t *buf, int len); void (*select_chip)(struct mtd_info *mtd, int chip); @@ -544,6 +648,7 @@ struct nand_chip { int feature_addr, uint8_t *subfeature_para); int (*onfi_get_features)(struct mtd_info *mtd, struct nand_chip *chip, int feature_addr, uint8_t *subfeature_para); + int (*setup_read_retry)(struct mtd_info *mtd, int retry_mode); int chip_delay; unsigned int options; @@ -566,7 +671,13 @@ struct nand_chip { int badblockbits; int onfi_version; - struct nand_onfi_params onfi_params; + int jedec_version; + union { + struct nand_onfi_params onfi_params; + struct nand_jedec_params jedec_params; + }; + + int read_retries; flstate_t state; @@ -600,6 +711,8 @@ struct nand_chip { #define NAND_MFR_AMD 0x01 #define NAND_MFR_MACRONIX 0xc2 #define NAND_MFR_EON 0x92 +#define NAND_MFR_SANDISK 0x45 +#define NAND_MFR_INTEL 0x89 /* The maximum expected count of bytes in the NAND ID sequence */ #define NAND_MAX_ID_LEN 8 @@ -805,4 +918,29 @@ static inline bool nand_is_slc(struct nand_chip *chip) { return chip->bits_per_cell == 1; } + +/** + * Check if the opcode's address should be sent only on the lower 8 bits + * @command: opcode to check + */ +static inline int nand_opcode_8bits(unsigned int command) +{ + switch (command) { + case NAND_CMD_READID: + case NAND_CMD_PARAM: + case NAND_CMD_GET_FEATURES: + case NAND_CMD_SET_FEATURES: + return 1; + default: + break; + } + return 0; +} + +/* return the supported JEDEC features. */ +static inline int jedec_feature(struct nand_chip *chip) +{ + return chip->jedec_version ? le16_to_cpu(chip->jedec_params.features) + : 0; +} #endif /* __LINUX_MTD_NAND_H */ |