kernel_replicant_linux/Documentation/networking/dccp.txt, branch v4.4-rc7

doc: spelling error changes

2014-05-05T13:32:05+00:00

Fixed multiple spelling errors.

Acked-by: Randy Dunlap 
Signed-off-by: Carlos E. Garcia 
Signed-off-by: Jiri Kosina

doc:net: Fix typo in Documentation/networking

2013-10-30T21:10:20+00:00

Correct spelling typo in Documentation/networking

Signed-off-by: Masanari Iida 
Acked-by: Randy Dunlap 
Signed-off-by: David S. Miller

Merge branch 'for-next' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/trivial

2011-01-13T18:05:56+00:00

* 'for-next' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/trivial: (43 commits)
  Documentation/trace/events.txt: Remove obsolete sched_signal_send.
  writeback: fix global_dirty_limits comment runtime -> real-time
  ppc: fix comment typo singal -> signal
  drivers: fix comment typo diable -> disable.
  m68k: fix comment typo diable -> disable.
  wireless: comment typo fix diable -> disable.
  media: comment typo fix diable -> disable.
  remove doc for obsolete dynamic-printk kernel-parameter
  remove extraneous 'is' from Documentation/iostats.txt
  Fix spelling milisec -> ms in snd_ps3 module parameter description
  Fix spelling mistakes in comments
  Revert conflicting V4L changes
  i7core_edac: fix typos in comments
  mm/rmap.c: fix comment
  sound, ca0106: Fix assignment to 'channel'.
  hrtimer: fix a typo in comment
  init/Kconfig: fix typo
  anon_inodes: fix wrong function name in comment
  fix comment typos concerning "consistent"
  poll: fix a typo in comment
  ...

Fix up trivial conflicts in:
 - drivers/net/wireless/iwlwifi/iwl-core.c (moved to iwl-legacy.c)
 - fs/ext4/ext4.h

Also fix missed 'diabled' typo in drivers/net/bnx2x/bnx2x.h while at it.

dccp: make upper bound for seq_window consistent on 32/64 bit

2011-01-07T11:22:44+00:00

The 'seq_window' sysctl sets the initial value for the DCCP Sequence Window,
which may range from 32..2^46-1 (RFC 4340, 7.5.2). The patch sets the upper
bound consistently to 2^32-1 on both 32 and 64 bit systems, which should be
sufficient - with a RTT of 1sec and 1-byte packets, a seq_window of 2^32-1
corresponds to a link speed of 34 Gbps.

Signed-off-by: Gerrit Renker

dccp: Policy-based packet dequeueing infrastructure

2010-12-07T12:47:12+00:00

This patch adds a generic infrastructure for policy-based dequeueing of
TX packets and provides two policies:
 * a simple FIFO policy (which is the default) and
 * a priority based policy (set via socket options).
Both policies honour the tx_qlen sysctl for the maximum size of the write
queue (can be overridden via socket options).

The priority policy uses skb->priority internally to assign an u32 priority
identifier, using the same ranking as SO_PRIORITY. The skb->priority field
is set to 0 when the packet leaves DCCP. The priority is supplied as ancillary
data using cmsg(3), the patch also provides the requisite parsing routines.

Signed-off-by: Tomasz Grobelny 
Signed-off-by: Gerrit Renker

Docs/Kconfig: Update: osdl.org -> linuxfoundation.org

2010-11-15T22:50:13+00:00

Some of the documentation refers to web pages under
the domain `osdl.org'. However, `osdl.org' now
redirects to `linuxfoundation.org'.

Rather than rely on redirections, this patch updates
the addresses appropriately; for the most part, only
documentation that is meant to be current has been
updated.

The patch should be pretty quick to scan and check;
each new web-page url was gotten by trying out the
original URL in a browser and then simply copying the
the redirected URL (formatting as necessary).

There is some conflict as to which one of these domain
names is preferred:

  linuxfoundation.org
  linux-foundation.org

So, I wrote:

  info@linuxfoundation.org

and got this reply:

  Message-ID: <4CE17EE6.9040807@linuxfoundation.org>
  Date: Mon, 15 Nov 2010 10:41:42 -0800
  From: David Ames 

  ...

  linuxfoundation.org is preferred. The canonical name for our web site is
  www.linuxfoundation.org. Our list site is actually
  lists.linux-foundation.org.

  Regarding email linuxfoundation.org is preferred there are a few people
  who choose to use linux-foundation.org for their own reasons.

Consequently, I used `linuxfoundation.org' for web pages and
`lists.linux-foundation.org' for mailing-list web pages and email addresses;
the only personal email address I updated from `@osdl.org' was that of
Andrew Morton, who prefers `linux-foundation.org' according `git log'.

Signed-off-by: Michael Witten 
Signed-off-by: Jiri Kosina

dccp ccid-3: use per-route RTO or TCP RTO as fallback

2010-08-30T20:45:28+00:00

This makes RTAX_RTO_MIN also available to CCID-3, replacing the compile-time
RTO lower bound with a per-route tunable value.

The original Kconfig option solved the problem that a very low RTT (in the
order of HZ) can trigger too frequent and unnecessary reductions of the
sending rate.

This tunable does not affect the initial RTO value of 2 seconds specified in
RFC 5348, section 4.2 and Appendix B. But like the hardcoded Kconfig value,
it allows to adapt to network conditions.

The same effect as the original Kconfig option of 100ms is now achieved by

> ip route replace to unicast 192.168.0.0/24 rto_min 100j dev eth0

(assuming HZ=1000).

Signed-off-by: Gerrit Renker 
Signed-off-by: David S. Miller

dccp ccid-2: Share TCP's minimum RTO code

2010-08-30T20:45:27+00:00

Using a fixed RTO_MIN of 0.2 seconds was found to cause problems for CCID-2
over 802.11g: at least once per session there was a spurious timeout. It
helped to then increase the the value of RTO_MIN over this link.

Since the problem is the same as in TCP, this patch makes the solution from
commit "05bb1fad1cde025a864a90cfeb98dcbefe78a44a"
       "[TCP]: Allow minimum RTO to be configurable via routing metrics."
available to DCCP.

This avoids reinventing the wheel, so that e.g. the following works in the
expected way now also for CCID-2:

> ip route change 10.0.0.2 rto_min 800 dev ath0

Luckily this useful rto_min function was recently moved to net/tcp.h,
which simplifies sharing code originating from TCP.

Documentation also updated (plus minor whitespace fixes).

Signed-off-by: Gerrit Renker 
Signed-off-by: David S. Miller

dccp: allow probing of CCID-array length

2010-02-12T19:47:00+00:00

This fixes a problem in the DCCP getsockopt() API: currently there is no way
for a user to a priori know the number of built-in CCIDs, other than trying
DCCP_SOCKOPT_AVAILABLE_CCIDS in a loop, incrementing the option length until
EINVAL is no longer returned.

This patch truncates the array to the user-provided length. No copy is made
when the length is <= 0.

Due to the length restriction in do_dccp_getsockopt() to sizeof(int), the
minimum array length remains 4, which is a reasonable default (only 3
CCIDs, CCID-2..4, are currently defined).

Signed-off-by: Gerrit Renker 
Signed-off-by: David S. Miller

dccp: Implement both feature-local and feature-remote Sequence Window feature

2009-01-21T22:34:04+00:00

This adds full support for local/remote Sequence Window feature, from which the
  * sequence-number-validity (W) and
  * acknowledgment-number-validity (W') windows
derive as specified in RFC 4340, 7.5.3.

Specifically, the following is contained in this patch:
  * integrated new socket fields into dccp_sk;
  * updated the update_gsr/gss routines with regard to these fields;
  * updated handler code: the Sequence Window feature is located at the TX side,
    so the local feature is meant if the handler-rx flag is false;
  * the initialisation of `rcv_wnd' in reqsk is removed, since
    - rcv_wnd is not used by the code anywhere;
    - sequence number checks are not done in the LISTEN state (cf. 7.5.3);
    - dccp_check_req checks the Ack number validity more rigorously;
  * the `struct dccp_minisock' became empty and is now removed.

Signed-off-by: Gerrit Renker 
Acked-by: Ian McDonald 
Signed-off-by: David S. Miller