1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
|
@TEMPLATE decoder_tmpl.c
Postprocessing Decoder
======================
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ INTRODUCTION
This example adds postprocessing to the simple decoder loop.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ INTRODUCTION
Initializing Postprocessing
---------------------------
You must inform the codec that you might request postprocessing at
initialization time. This is done by passing the VPX_CODEC_USE_POSTPROC
flag to `vpx_codec_dec_init`. If the codec does not support
postprocessing, this call will return VPX_CODEC_INCAPABLE. For
demonstration purposes, we also fall back to default initialization if
the codec does not provide support.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ DEC_INIT
/* Initialize codec */
res = vpx_codec_dec_init(&codec, interface, NULL,
VPX_CODEC_USE_POSTPROC);
if(res == VPX_CODEC_INCAPABLE) {
printf("NOTICE: Postproc not supported by %s\n",
vpx_codec_iface_name(interface));
res = vpx_codec_dec_init(&codec, interface, NULL, flags);
}
if(res)
die_codec(&codec, "Failed to initialize decoder");
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ DEC_INIT
Using Adaptive Postprocessing
-----------------------------
VP6 provides "adaptive postprocessing." It will automatically select the
best postprocessing filter on a frame by frame basis based on the amount
of time remaining before the user's specified deadline expires. The
special value 0 indicates that the codec should take as long as
necessary to provide the best quality frame. This example gives the
codec 15ms (15000us) to return a frame. Remember that this is a soft
deadline, and the codec may exceed it doing its regular processing. In
these cases, no additional postprocessing will be done.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ DECODE
/* Decode the frame with 15ms deadline */
if(vpx_codec_decode(&codec, frame, frame_sz, NULL, 15000))
die_codec(&codec, "Failed to decode frame");
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ DECODE
Codec Specific Postprocessing Controls
--------------------------------------
Some codecs provide fine grained controls over their built-in
postprocessors. VP8 is one example. The following sample code toggles
postprocessing on and off every 15 frames.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ PRE_DECODE
#if CONFIG_VP9_DECODER
if(frame_cnt%30 == 1) {
vp8_postproc_cfg_t pp = {0, 0, 0};
if(vpx_codec_control(&codec, VP8_SET_POSTPROC, &pp))
die_codec(&codec, "Failed to turn off postproc");
} else if(frame_cnt%30 == 16) {
vp8_postproc_cfg_t pp = {VP8_DEBLOCK | VP8_DEMACROBLOCK | VP8_MFQE, 4, 0};
if(vpx_codec_control(&codec, VP8_SET_POSTPROC, &pp))
die_codec(&codec, "Failed to turn on postproc");
};
#endif
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ PRE_DECODE
|
